hd firing pin return spring encore prohunter endeavor
An essential upgrade on every Encore, Prohunter, FX, Endeavor, and Omega. One look at the picture and you can see the difference. Spring on the right is a stock spring with around 150 rounds use. Spring on the left is our new spring, notice the additional coils. We design our spring TO LAST and hold up to the abuse the hammer puts on the firing pin.
Our heavy duty firing pin return springs are heat treated and designed to absorb the impact of heavier hammer springs and repeated use. Because our springs are a larger wire diameter than the factory, headspace correction is recommended but these also work great for a stock replacement. Price for 1 each, we also offer a 5 pack.
No gunsmith Needed, ANYONE can do this. With the barrel removed put your finger inside right of frame to hold the spring loaded flat piece of metal called the interlock to the rear of the frame to allow you to cock the hammer. With a 7/64 allen key remove the bolt that is directly above the back of the firing pin on the outside back strap of frame. The firing pin bushing firing pin and spring come out the front. Now is a great time to clean inside this part of the frame and inspect the firing pin for damage and needing replaced. The cone of the firing pin faces the cone tip of the spring pre install in the firing pin bushing then carefully reinstall the bushing to the frame making sure the threaded part of bushing aligns with the hole and threads of firing pin screw. Don't over tighten the screw. Pull the trigger and manually let the hammer done. Simple Job Done! Great job.
[ITEMPRICE]